HowTo: Enable Traceroute on HPE FF5700

On HPEs Comware based FlexFabric switches by default answering to traceroute is disabled. To enable traceroute on a FF5700 families switch you need to activate:


ip unreachable enable
ip ttl-expires enable

As of then, the switch should show up in traceroutes with something different than timeouts.

Kyp. F.

How-To: Init HPE FF5700 FlexFabric Switches

Left alone by some consultants, which charged a lot and did not accomplish to much, I ended up configuring FF5700 felx fabric switches myself. Some of the insights, other posts will follow.

To start with the basic initialization settings, configuring management access and doing initial firmware maintenance. After unpacking the switch and mounting fans and power supplies connect through the serial console – although there is dhcp client running on the switch which probably allows you to gain management access over the network. Remember there is a Gigabit- Ethernet- Port on the backside of the switch, dedicated for management access only. The console port is adjacent. Default serial settings are 9600/n/1/n as with any other HPE switch.

After the boot procedure press enter and you have access to the switch. Elevate your access level to configuration mode with:

system-view

To start with I actually disable the DHCP client and activate LLDP for further use.

undo dhcp enable
lldp global enable

After that prepare the desired VLANs according to whatever you later use. I strictly recommend leaving the default VLAN untouched, leaving the Primary VLAN ID on 1 and transport that untagged on any switch to switch link, but remove all access and server Continue reading

How-To: HPE FF5700 10G and Adapter Teaming to Windows 2012 R2

Vor einigen Wochen sind wir mit HPEs recht neuen 40G FlexFabric Switches aus der 5700er Familie gestartet.

Dem Duty Manager – bei HPE Service nach braucht man ja ein Installation Carepack um eine gescheite Firmware Version zu kriegen – dreimal darf der geneigte Leser raten was ich davon halte. Eine Aussage für die eben jene Hotline immerhin auch 144 Stunden während einer kritischen Inbetriebnahme gebraucht hat. Aber glücklicherweise ist dem nicht so und nach zehn ziemlich spannenden Tagen sind die Dinger jetzt tatsächlich im ruhigen Fahrwasser angekommen.

Zeit erste Konfigurationen aus dem Tagesgeschäft vor zu nehmen. Da wir eine IRF Konfiguration haben um einen komfortablen redundanten Netzwerk Core zu erhalten, bietet sich an auch Server per LACP an zu binden. Im IRF kann man ebendas Chassis- übergreifend auch Link Aggregation Groups anlegen. Dabei geht IRF über klassisches Continue reading