How To: Firmware Upgrade on an VSF-Stack

Having created a VSF stack of Aruba 2930Fs, the immediate need of firmware maintenance is obviously raising the question of how!. Dealing with that, luckily a new software had been released and I was able to test.

Daring the result … it was shocking simple and runs as every other Aruba / Procurve firmware upgrade and you just have to cover the second vsf stack member.


vsf member 1
copy tftp flash 192.168.2.5 WC_16_07_0002.swi primary
vsf member 2
copy tftp flash 192.168.2.5 WC_16_07_0002.swi primary

 

Verify the upload with a show flash the firmware image something like, even you may Continue reading

How To: High Availability with Aruba 2930F – VSF

Considering recent posts on IRF, there was a need to get some availability with the more cost effective switches from the Aruba / ProCurve world. I did some research on that and luckily there are more than one option today with this platform – at least the 5400s (…) and in my case 2930s support this by default.

Considering redundancy you basically consider two types of high availability and these cover Layer 2 availability, traditionally suited with link aggregation which conventionally does not span several chassis, and Layer 3 availability for a redundant default gateway service.

In a traditional design, then with a couple of switches (at least four), you configure VRRP for L3 redundant default gateway service, LACP – link aggregation groups for L2 Continue reading